Easton X10 Fletched Arrow - Dozen

Easton X10 Fletched Arrow - Dozen

Easton X10 Arrows, Easton's top of the range arrow. A slightly heavier arrow but with a very small diameter gives this shaft a high performance. The perfect 10 hands down. Small diameter barrelled profile resists wind drift better than any other type of arrow.

• High-strength carbon fibre bonded to a 7075 alloy core
• 9-micron polished carbon finish
• Guaranteed straightness: ±.0015”
• Weight tolerance: ± 0.5 grains

Build preference: Our arrow builder allows you to make your arrows the way you want them, select your preferences from the list and the price will adjust according to your choices. We have built a compatibility table for each arrow so you will only be shown options that are compatible with the choices that you have made.

We have built a fletching charge into the cost of the shafts which is why the cost of the shafts appears higher than if you were buying them separately. 

If you wish to have these arrows fletched with Eli vanes, KSL Jet 6 vanes or Spin Wing Vanes then you can choose them from the 'cock fletch' drop-down menu and for the hen just select 'same as cock fletch' - these three fletching options come in packs of 50, any fletchings not used will be sent with the arrows as spares. Because these fletchings take a long amount of time to properly fletch we also include a fletching charge in the price of these fletchings.

You can choose from a range of options when building your arrows:

• Nocks: Easton Pin Nocks, Easton G pin nocks or Beiter pin nocks (#1, #2 or hunter)
• Points: steel or tungsten 
• Fletchings: AAE EP16, Bohning X or air vanes

AMO Arrow Length / Break-off point weight

When entering your required arrow/shaft length please enter the AMO length - this is the length of the arrow from the inside of the nock to the end of the shaft (Excluding the point) in inches. Please refer to the below diagram as an example.

If you have chosen break-off points and would like the points broken down to a lighter weight then please also enter your required weight in the text box next to your AMO arrow length (e.g 29" 90gr). If you haven't chosen break-off points then you only need to enter your AMO arrow length, if no point weight is entered then we won't break them down.

If you already have a set of arrows/shafts you can send in one and we will use your sample arrow to set up our saw to ensure the length of the arrows match perfectly.

Please note - the max stock length listed below is the shortest length that the spine will be from the factory, in some batches that we receive from Easton they are longer than the listed length (but never shorter). If you enter a length longer than the listed max stock length then we will check to see if your requested length is available otherwise, we will let you know what the current max length is.