Easton Avance Sport Fletched Arrow - Single

Easton Avance Sport Fletched Arrow - Single

Easton’s new Avance Sport 4MM arrows are an all-carbon target arrow intended to fit in the middle of the outdoor target archery market. Avance Sport shares the same carbon construction and is then sorted into by straightness. The Avance Sport carries a +/- .005” straight spec, ideal for novice level archers looking for lightweight performance in a less expensive arrow.

The Avance series is available in a wide selection of spine sizes that cover tuning ranges for recurve and compound archers over a broad range of bow styles, draw lengths and poundages. The durable, all-carbon construction of the Avance nets an arrow that is lighter than previous Easton offerings, allowing for top-level performance and greatly benefiting the entry-level to intermediate-level target archer. Accompanying the Avance is a full line of glue-in target points, pin inserts, pin nocks and push in nocks.

SPECIFICATIONS

• 4MM all-carbon target archery arrows
• Avance Sport +/-.005” straightness
• Designed to offer high performance to entry-level and intermediate-level recurve and compound archers
• Lighter weight than previous category arrows (Carbon One and Apollo)
• Available in 16 sizes from 340-2000

Build preference: Our arrow builder allows you to make your arrows the way you want them, select your preferences from the list and the price will adjust according to your choices. We have built a compatibility table for each arrow so you will only be shown options that are compatible with the choices that you have made.

We have built a fletching charge into the cost of the shafts which is why the cost of the shafts appears higher than if you were buying them separately. 

If you wish to have these arrows fletched with Eli vanes, KSL Jet 6 vanes or Spin Wing Vanes then you can choose them from the 'cock fletch' drop-down menu and for the hen just select 'same as cock fletch' - these three fletching options come in packs of 50, any fletchings not used will be sent with the arrows as spares. Because these fletchings take a long amount of time to properly fletch we also include a fletching charge in the price of these fletchings.

You can choose from a range of options when building your arrows.

• Nocks: Beiter Insert Nock 166, Easton G Pin Nock, Bohning Smooth Release Pin, Bohning Blazer Pin, Easton Pin Nock, Easton G-Nocks or Beiter Pin Nock.
• Points: Easton 4mm ML Break-off Point
• Fletchings: AAE Elite Plastifletch Vanes, Bohning Air Vanes 2", Bohning Impulse Vanes 3" or Bohning X-Vanes Shield Cut 1.5"

AMO Arrow Length

When entering your required arrow/shaft length please enter the AMO length - this is the length of the arrow from the inside of the nock to the end of the shaft (Excluding the point) in inches. Please refer to the below diagram as an example.

If you already have a set of arrows/shafts you can send in one and we will use your sample arrow to set up our saw to ensure the length of the arrows matches perfectly.

The arrow length we cut these to will be using the standard nocks that come with the arrow shafts, if you intend to use different nocks and want your arrow length to be measured using non-standard nocks then please mention this in the comments box on the checkout page.

Nocks:

Vanes: